Omron V1000 User Manual page 191

5.8 L: Protection Functions
(H1- = 65 or 66)
Note: If L2-06 is set to 0.0 s, C1-09 is used instead. If L2-07 is set to 0.0 s, the drive reaccelerates using the selected acceleration time.
Use this method with setting parameters L2-06 and L2-07 if multiple drives must decelerate but still keep the speed ratio
between the drives constant during power loss. In this case, a braking resistor is required in order to avoid overvoltage
trips.
KEB2
In this mode the drive decelerates the motor by calculating the energy of the rotating system. The deceleration rate is
continuously adjusted so that the DC bus voltage meets the level set in parameter L2-11. The rotational energy is estimated
using the parameters L3-24 and L2-25. When the power supply returns, the drive accelerates back to the frequency reference
using the selected acceleration time.
Activation and Deactivation of the KEB Function
The KEB function requires parameter L2-01 to be set to 1 or 2 and a digital input has to be configured for the KEB 1 (H1-
 = 65/66) or KEB 2 (H1- = 7A/7B) command. The input has to be enabled during KEB.
KEB Ride-Thru 1 (N.C.)/2 (N.O.) on page 167
168 for details on setting the KEB input commands.
The KEB function is automatically activated when one of the conditions below becomes true.
• The DC bus voltage falls below the level set in parameter L2-05. The KEB input has to be set within 50 ms after the
KEB function was activated, or the drive will assume the power supply has returned and attempt to restart.
• The input programmed for KEB 1 or 2 is activated. This input should be triggered by an external undervoltage detection
relay.
The KEB function ends when one of the conditions below become true.
• The KEB input was released or
• The function was activated by DC bus voltage detection and no KEB input was set within 50 ms after the KEB activation.
Figure 5.78 shows a wiring example for triggering the KEB function at power loss using digital input S6.
Note: Make sure the Run command is not switched off when momentary power loss occurs. If the Run command is shut off, the drive will not
accelerate back to speed when the power is restored.
KEB Related Adjustment Parameters
The KEB 1 functions can be adjusted using the following parameters:
190
OFF
KEB Ride-Thru
Output
frequency
Figure 5.77 KEB Ride-Thru Timing Diagram for Multiple Drives
and Refer to Setting 7A/7B: KEB Ride-Thru 2 (N.C./N.O.) on page
L1
L2
L3
UV Detection
Relay
S6 - KEB command 1 or 2
S1 - Start command
SC
Figure 5.78 KEB Function Wiring Example
ON OFF
L2-06
Braking
Resistor
B1 B2
R/L1
U/T1
S/L2
V/T2
T/L3
W/T3
SIEP C710606 20 OYMC AC Drive - V1000 User Manual
L2-07
Refer to Setting 65/66:
M