Omron V1000 User Manual page 160

Setting 0: User Defined Setting
Setting 1: BOOTP
Setting 2: DHCP
n F7-14: Ethernet Duplex Mode Selection
Sets the duplex mode for Ethernet communications.
No.
<1>
F7-14
<1> Valid from drive software version 1011 and later. Parameter number was F7-15 in older software.
Setting 0: Auto Negotiate
Setting 1: Half Duplex Forced
Setting 2: Full Duplex Forced
n F7-15: Ethernet Communication Speed Selection
Sets the duplex mode for Ethernet communications.
No.
<1>
F7-15
<1> Valid from drive software version 1011 and later. Parameter number was F7-18 in older software.
Setting 0: Auto Detection
Setting 10: 10 Mbps
Setting 100: 100 Mbps
n F7-16: Ethernet Communication Loss Time Out
Sets the communication loss time out value.
No.
<1>
F7-16
<1> Valid from drive software version 1011 and later. Parameter number was F7-21 in older software.
n
F7-17 to F7-22: EtherNet Scaling Factors
These parameters define scaling factors for drive monitors in the EtherNet Class ID 2AH - AC Drive Object.
No.
<1>
F7-17
<1>
F7-18
<1>
F7-19
<1>
F7-20
<1>
F7-21
<1>
F6-22
<1> Valid from drive software version 1011 and later.
Setting
The monitor value in the Class 2AH - AC Drive Object is calculated by:
Class 2AH Object Monitor = Drive Value x 2
Example:
If the drive output frequency monitor (U1-02) is 50.0 and the scaling is set to F7-17 = 3, then the value in the Class 2AH
- AC Drive Object, Instance 1, Attribute 7 would be 500 x 2
SIEP C710606 20 OYMC AC Drive - V1000 User Manual
Parameter Name
Duplex Mode Selection
Parameter Name
Communication Speed Selection
Parameter Name
Communication Loss Time Out
Parameter Name
EtherNet Speed Scaling
EtherNet Current Scaling
EtherNet Torque Scaling
EtherNet Power Scaling
EtherNet Voltage Scaling
EtherNet Time Scaling
Scaling
Setting Range
0 to 2
Setting Range
0, 10, 100
Setting Range
0 to 300
Setting Range
-15 to 15
-15 to 15
-15 to 15
-15 to 15
-15 to 15
-15 to 15
3
= 4000.
5.6 F: Option Settings
Default
0
Default
0
Default
0
Default
0
0
0
0
0
0
159
5