How To Load And Unload Using A Truck - OREC AHRC 663 Operating Instructions Manual

How to load and unload using a truck

 Park the truck on a flat and stable surface. Switch off the truck's engine, engage reverse gear, and pull
the parking brake. Also place chucks under the truck's wheels to stop it from moving.
 Before loading or unloading, raise the height of the blades so that they will not contact the ramp. There
is a danger of the blades catching on the ramp, possibly causing the machine to roll over.
 Attach the ramp's hook so that there is no bump where it attaches to the truck's loading bed. Also
make sure that the ramp is securely attached.
 Use caution when the machine crosses from the ramp to the truck's loading bed and the location of the
center of gravity is suddenly changed.
 Do not stand on the front of the machine.
 Do not operate any of the machine's levers while on the ramp as there is a danger of the machine
rolling over.
 Make sure that the rubber crawler tracks on either side of the machine are positioned centrally on the
ramp.
 When loading and transporting by truck, engage the machine's parking break and secure the machine
in the loading bed with a rope that is sufficiently strong enough. Also place chucks under the machine's
wheels to stop it from moving.

How to load and unload
Use of side clutch is
strictly prohibited.
Ref: Ramp standards
Make sure that your ramp is comprised of materials strong enough to conform to the following standards.
 Length:
 Width:
 Strength:
 Surface:
1. Park your vehicle on a flat surface with no dangerous objects
nearby.
2. Attach a ramp which conforms to the standards below.
3. Put the throttle lever in the intermediate position between
[
4. Only load the machine in forward gear [1] and only unload in
reverse [R]. Do not use any other gear.
3.5 times longer than the truck's loading bed is high.
At least as wide as the wheel span of the machine.
Sufficiently strong enough to take the weight of the sum total of the
machine and the operator.
Use a ramp with a non-slip surface.
(HI)] and [ (LOW)].
22