5. Remove the side covers from the protective flap
6. Close the protective flap until you hear it snap into place.
11.4.6.6
Mounting the DC link adapter (4 screws)
Overview
For a multi-tier configuration, if you wish to mount the DC link adapter on the right-hand side of
a 150 mm or 200 mm wide component, then it is mounted using 4 screws.
Requirement
The installation must comply with the following requirements in order to use the DC link adapter:
• The component line-up has a two or multi-tier configuration.
• The DC link adapter is supplied with shims. These are required for SINAMICS S120 booksize
components, and are not relevant for mounting on SINAMICS S220 booksize components.
Required tools:
• Slotted screwdriver 1.0 x 5.5 mm to release the protective flap
• Torx screwdriver TX 20
Booksize power units
Equipment Manual, 09/2023, A5E53307519B AA
Accessories
11.4 DC link adapter
303