Table of Contents
Advertisement
①
Figure 11-6
1. Prepare the hole in the control cabinet.
– As depicted above, you can screw the removable O-ring from the inside or the outside.
2. Insert the DRIVE-CLiQ cabinet bushing from the outside of the control cabinet through the
cutout in the control cabinet.
3. Attach the DRIVE-CLiQ cabinet bushing by tightening the nut with a tightening torque of
3 ... 4 Nm (26.6 ... 35.4 lbf in).
①
②
③
④
Booksize power units
Equipment Manual, 09/2023, A5E53307519B AA
Threaded hole with chamfer
Threaded hole with an O-ring that can be screwed from the outside
Flange, size 18
Seal (O-ring)
Cabinet panel
Nut, size 20, tightening torque: 3 ... 4 Nm (26.6 ... 35.4 lbf in)
Accessories
11.3 DRIVE-CLiQ cabinet bushing
277
Advertisement
Table of Contents
