Siemens SINAMICS S220 Equipment Manual page 131

Procedure
Table 7-8
Rated power
Width
Rear view
Fit the Smart Line Module on the mounting panel as follows:
1. Prepare the mounting panel.
2. Screw the four M6 screws in far enough that you can attach the component.
3. Attach the component.
4. Tighten the screws finger-tight. Tightening torque: 0.5 Nm (4.4 lbf in)
5. Then tighten the screws fully. Tightening torque: 6 Nm (53.1 lbf in)
Booksize power units
Equipment Manual, 09/2023, A5E53307519B AA
Rear view of 16 kW and 24 kW Smart Line Modules – mm and (inches)
7.11 Install the Smart Line Module
16 kW and 24 kW
100 mm
Smart Line Modules
129