Motor Modules
8.5 Motor Modules 85 A, 132 A and 200 A
Proceed as follows to mount the shield connection plate:
1. Prepare the mounting panel.
2. Fasten the shield connection plate to the mounting panel using screws at the prepared
distance.
3. Tighten the screws. Tightening torque: 6 Nm (53.1 lbf in)
8.5.9
Mounting the fan
Overview
The fan must also be mounted when mounting Motor Modules 85 A ... 200 A.
Install the fan module provided with the Motor Module.
Requirement
Note the following before installing the fan module in the Motor Module:
• The shield connection plate is mounted.
Required tool:
• T20 torx screwdriver
Procedure
Figure 8-79
232
Mounting the fan
Booksize power units
Equipment Manual, 09/2023, A5E53307519B AA