Selecting Encoder Modes - Yamaha 02R96 Owner's Manual

50
Chapter 3—Operating Basics

Selecting Encoder Modes

The exact function of each Encoder depends on the selected Layer and Encoder
mode. There are two preset Encoder modes, Pan and Aux, and two assignable
modes, for which you can choose from over 40 parameters.
1 Select a Layer, as explained in page 47.
Use the ENCODER MODE buttons to select an Encoder mode.
2
[PAN]: Encoders function as Pan controls.
[AUX]: Encoders control Aux Send levels, depending on the selected Layer.
[ASSIGN 1/2]: Encoders control the parameters assigned to the ASSIGN buttons. See
"Assigning Parameters to the ENCODER MODE Assign Buttons" on page 51 for more
information.
The indicator of the currently selected ENCODER MODE button lights up.
The following table shows the exact Encoder functions for each Layer and Encoder mode.
Layer
1–24
25–48
Master
Remote
1. When Alt Layer is assigned, the Encoders enable you to control a parameter that is assigned to the cor-
responding channel fader in the partner layer. (A partner layer would be the layer of channels 25-48
if the layer of channels 1-24 is currently selected.)
02R96 Version 2—Owner's Manual
ENCODER MODE
DISPLAY
PAN
Encoder
Mode
1–8
Pan
Aux
Assign 1/2
Pan
Aux
Assign 1/2
Input Channels 49–56
Pan
pan
Input Channels 49–56
Aux
Aux Send level
Input Channels 49–56
Assign 1/2
assigned parameter
Pan
Aux
See "About the Remote Layer" on page 219 for more information.
Assign 1/2
1 2
AUX
ASSIGN ASSIGN
Encoder
9–16
Input Channels 1–24 pan
Input Channels 1–24 Aux Send level
Input Channels 1–24 assigned parameter
Input Channels 25–48 pan
Input Channels 25–48 Aux Send level
Input Channels 25–48 assigned parameter
No operation
No operation
Aux Sends 1–8
assigned parameter
Operation depends on the selected target.
17–24
1
1
Bus Outs 1–8 assigned
parameter