Yamaha 02R96 Owner's Manual page 173

FADER EDIT: These buttons are used to set the Fader Edit mode: Absolute or Relative. The
Fader Edit mode determines how fader moves are rerecorded. It has no effect during the
first recording pass. In Absolute mode, fader moves are rerecorded as absolute values and
existing fader data is erased. In Relative mode, fader moves are rerecorded relative to the
existing fader data.
Fader data includes Input Channel levels, Bus Out master levels, Aux Send master levels,
Stereo Out level, User Defined Remote Layer faders, and Group master levels.
The following table explains Fader Edit mode operation (TO END: off. Edit Out: off)
Absolute
Fader edits are recorded as absolute values and
existing fader data between the punch in and out
points is erased.
Existing data
Fader edit
Punch in Punch out
TOUCH SENSE: When the TOUCH button is selected, the Touch Sense function enables
you to touch the faders to punch parameter values in and out. The corresponding parame-
ters' OVERWRITE button must be set to on. When the LATCH button is selected, only
punch in operations are available (the punch out function is disabled).
OVERWRITE: These buttons determine which parameters can be recorded on the first
pass, and rerecorded (i.e., overwritten) on subsequent passes. They can be set while record-
ing is in progress. Parameters for which the corresponding OVERWRITE button is not set,
cannot be edited while recording is in progress.
Parameter button
Channel faders (Inputs Channels, Bus Out masters, Aux Send masters, the Ste-
FADER
reo Out, Group master levels, and User Defined Layer faders)
Channel Mutes (ON/OFF), User Defined Layer [ON] buttons, and Group master
ON
ON
PAN
Input Channel Pan, User Defined Layer Encoders
SURR
Input Channel Surround pan, LFE level, DIV parameter, and RDIV parameter
AUX
Aux Send 1–8 levels
AUX ON
Aux Send 1–8 mutes
EQ
(F, Q, G, On/Off)
EQ
Scene and library recalls, and internal effects processors and Plug-Ins parameters can be
recorded regardless of the OVERWRITE settings.
AUTOMIX: This button is used to enable and disable the Automix function. It works in
unison with the AUTOMIX [ENABLE] button.
NEW: This button is used to create a new Automix. When a new Automix is created, a
Scene recall event to recall the current Scene (i.e., the last Scene recalled) is automatically
inserted at the start of the Automix. You can edit this event so that another Scene is recalled.
This initial Scene is important because it sets all the mix parameters how you'd like them at
the beginning of the Automix. Without it, mix parameters would remain the same as when
Automix playback was stopped.
Automix Main Page
Fader edits are rerecorded relative to the existing
fader data.
Time
Punch in
Description
173
Relative
Existing data
Fader edit
Time
Punch out
02R96 Version 2—Owner's Manual