Naming Input & Output Ports; Patch Select Window - Yamaha 02R96 Owner's Manual

Naming Input & Output Ports
You can specify Long and Short names for the Input and Output Ports as follows. These
names appear on the Input and Output Patch pages.
See page 251 for a list of the initial Input Port names; page 252 for Output Port names.
Use the DISPLAY ACCESS [SETUP] button to locate the Input Port or Output
1
Port Name page.
Use the Parameter wheel or INC/DEC buttons to select the ports.
2
Use the cursor buttons to select the Long or Short name, and then press
3
[ENTER].
When the Title Edit window appears, edit the port name, and press OK when you've fin-
ished. See "Title Edit Window" on page 46 for more information.
When the Name Input Auto Copy option is on, the first four characters of a newly entered
Long name are automatically copied to the Short name and vice versa.
You can reset all port names back to their initial values by pressing the INITIALIZE button.

Patch Select Window

Input and Output patches can be made by using the Patch Select window, shown below,
which appears when the [ENTER] button is pressed while a patch parameter is selected.
Available input and output sources and destinations are displayed in a hierarchical format
in three panes. The existing source or destination is displayed in the upper-right corner of
the window. Use the cursor buttons to move the cursor to the pane on the left, and use the
Parameter wheel or INC/DEC buttons to select the top level item. Then move the cursor to
the center pane, and select an item at the next level. Select an item in the right pane, if avail-
able, and then select the YES button and press [ENTER].
Naming Input & Output Ports
02R96 Version 2—Owner's Manual
71