Soloing Channels; Viewing Send Destinations; Configuring Sends As Pre Or Post; Setting Send Levels - Yamaha 02R96 Owner's Manual

210
Chapter 18—Pro Tools Remote Layer

Soloing Channels

Channels can be soloed as follows.
Use the [SOLO] buttons to solo channels.
1
The [SOLO] button indicators of soloed channels light up and the [ON] button indicators
of unsoloed channels flash.
Press the [SOLO] buttons again to unsolo channels.
2
Grouped channels are soloed together.

Viewing Send Destinations

Send destinations can be viewed in Channel Display mode [F3] or Meter Display mode [F4]
(see page 200) by pressing the holding the AUX SELECT [AUX 1]–[AUX 5] (SEND A–E)
buttons.
Configuring Sends as Pre or Post
Sends can be configured as either pre or post as follows.
(Make sure the ENCODER MODE [PAN] (PAN) button indicator is not lit before proceed-
ing.)
Use the AUX SELECT [AUX 1]–[AUX 5] (SEND A–E) buttons to select the
1
sends.
The ENCODER MODE [AUX] (SEND LEVEL) button indicator lights up, as does the but-
ton indicator of the selected send.
2 Use the Encoder push-switches to toggle between pre and post.
Sends can also be set as pre or post fader by using the Encoder push-switches in Flip mode.
See "Flip Mode" on page 211 for more information.
Send pre/post status can be viewed in Channel Display mode [F3] or Meter Display mode
[F4] (see page 200) by pressing the holding the Encoder push-switches.

Setting Send Levels

Send levels can be set as follows.
1 Use the AUX SELECT [AUX 1]–[AUX 5] (SEND A–E) buttons to select the
sends.
The ENCODER MODE [AUX] (SEND LEVEL) button indicator lights up, as does the but-
ton indicator of the selected send.
The levels for the selected send are displayed in Channel Display mode. See "Channel Dis-
play Mode" on page 200 for more information.
Use the Encoders to set the send levels.
2
Send levels can also be set by using the faders in Flip mode. See "Flip Mode" on page 211 for
more information.

Muting Sends

Sends can be muted by using the [ON] buttons in Flip mode. See "Flip Mode" on page 211
for more information.

Panning Sends

Only sends assigned to stereo destinations can be panned. Sends can be panned by using the
Encoders in Flip mode. See "Flip Mode" on page 211 for more information.
02R96 Version 2—Owner's Manual