Automation - Yamaha 02R96 Owner's Manual

216
Chapter 18—Pro Tools Remote Layer
To stop scrub/shuttle, press the [SCRUB] or [SHUTTLE] button again, or press
4
the [STOP] button.
If you press the [REW], [FF], or [PLAY] button, scrub/shuttle operation is stopped before
rewind, fast forward, or playback commences.
While scrub/ shuttle is active, only the following Pro Tools/02R96 controls can be used:
[SCRUB] and [SHUTTLE] buttons, Parameter wheel, transport buttons, faders, [ON] but-
tons, and [SOLO] buttons. The current position can be stored as a marker by pressing the
[ENTER] button.
The scrub resolution depends on the current zoom setting, the more zoomed in you are, the
higher the resolution.

Automation

Viewing the Automation Mode
The Automation mode setting of each channel can be viewed as follows.
Press either the [F3] or [F4] button.
1
Channel Display mode or Meter Display mode is selected.
Press and hold a channel's [AUTO] button.
2
The channel's Automation mode is displayed while the [AUTO] button is pressed.
Auto write
Auto touch
Auto latch
Auto read
Auto off
For MIDI tracks, "—" appears on the display.
The Automation mode settings of all channels can be viewed as follows.
Press and hold the USER DEFINED [DISPLAY] (AUTO STATUS) button.
3
The Automation modes of all channels are displayed while the USER DEFINED [DISPLAY]
(AUTO STATUS) button is pressed.
Setting the Automation Mode
The Automation mode can be set as follows.
While holding down a channel's [AUTO] button, press the USER DEFINED [3]
1
(WRITE), [4] (TOUCH), [5] (LATCH), [6] (READ), [7] (TRIM), or [8] (OFF) but-
ton.
If Channel Display mode or Meter Display mode is currently selected, the channel's Auto-
mation mode is displayed while the [AUTO] button is pressed.
Grouped channels are set together.
02R96 Version 2—Owner's Manual
Pro Tools Display
Wrt
Flashing red (Record Ready)
Tch
Red (Recording)
Ltch
Read Green
Off Off
[AUTO] Button Indicators