Yamaha 02R96 Owner's Manual page 270

270
Appendix A: Parameter Lists
REV+FLANGE
One input, two output reverb and flanger effects in parallel.
Parameter
REV TIME
INI. DLY
HI. RATIO
DIFF.
DENSITY
HPF
LPF
REV/FLG
FREQ.
DEPTH
MOD. DLY
FB. GAIN
WAVE
SYNC
NOTE
1.
REV->FLANGE
One input, two output reverb and flanger effects in series.
Parameter
REV TIME
INI. DLY
HI. RATIO
DIFF.
DENSITY
HPF
LPF
REV.BAL
FREQ.
DEPTH
MOD. DLY
FB. GAIN
WAVE
SYNC
NOTE
1.
02R96 Version 2—Owner's Manual
Range
0.3–99.0 s Reverb time
0.0–500.0 ms Initial delay before reverb begins
0.1–1.0 High-frequency reverb time ratio
0–10 Spread
0–100% Reverb density
THRU, 21.2 Hz–8.00 kHz High-pass filter cutoff frequency
50.0 Hz–16.0 kHz, THRU Low-pass filter cutoff frequency
0–100% Reverb and flange balance (0% = all reverb, 100% = all flange)
0.05–40.00 Hz Modulation speed
0–100% Modulation depth
0.0–500.0 ms Modulation delay time
Feedback gain (plus values for normal-phase feedback, minus val-
–99 to +99%
ues for reverse-phase feedback)
Sine, Tri Modulation waveform
OFF/ON Tempo parameter sync on/off
1
Used in conjunction with TEMPO to determine FREQ.
Range
0.3–99.0 s Reverb time
0.0–500.0 ms Initial delay before reverb begins
0.1–1.0 High-frequency reverb time ratio
0–10 Spread
0–100% Reverb density
THRU, 21.2 Hz–8.00 kHz High-pass filter cutoff frequency
50.0 Hz–16.0 kHz, THRU Low-pass filter cutoff frequency
Reverb and flanged reverb balance (0% = all flanged reverb, 100%
0–100%
= all reverb)
0.05–40.00 Hz Modulation speed
0–100% Modulation depth
0.0–500.0 ms Modulation delay time
Feedback gain (plus values for normal-phase feedback, minus val-
–99 to +99%
ues for reverse-phase feedback)
Sine, Tri Modulation waveform
OFF/ON Tempo parameter sync on/off
1
Used in conjunction with TEMPO to determine FREQ.
Description
Description