Group Master For Input Channel Faders - Yamaha 02R96 Owner's Manual

80
Chapter 7—Input Channels
Use the LAYER buttons to select the Layers.
2
The corresponding Fader Group page and group row is selected as each Layer is selected.
Use the Up/Down cursor buttons to select Fader groups A–H.
3
The selected group is highlighted by a flashing cursor box.
Use the [SEL] buttons to add and remove faders to and from the selected
4
group.
When an Input Channel is added to a group, its [SEL] button indicator lights up.
ENABLE: These buttons are used to enable and disable the groups.
INPUT FADER MASTER: When this check box is unchecked, the Input Channel fader
positions link to the fader levels for the channels in the corresponding Fader group. When
this check box is checked, you can set the master level for the corresponding Input Channel
Fader group in the Master column. The resultant Input Channel level equals the corre-
sponding Input Channel fader level plus the Group Master level. See "Group Master for
Input Channel Faders" on page 80.
When the Input Fader Master check box is not checked, operating the channel faders will
affect the input levels for the corresponding Fader group. Pressing and holding down the
[SEL] button while operating the fader of an Input Channel will temporarily cancel the cor-
responding Fader group, which is convenient if you want to adjust the relative balance
between channels.
Fader groups are active only in Fader mode (i.e., when the FADER MODE [FADER] button
indicator is on). See "Selecting Fader Modes" on page 49 for more information.

Group Master for Input Channel Faders

The 02R96 features a Fader Group Master function that enables you to control the level of
all channels using the Group Master level while maintaining the relative balance between
channels, much like a VCA group on an analog mixing console. While this function is
enabled, channel fader operation does not affect channel levels in the corresponding Fader
group.
Follow Steps 1–4 as described in the "Grouping Input Channel Faders" sec-
1
tion on the previous page, select the Input Fader Master check box, then
press the [ENTER] button to check or uncheck the Input Fader Master check
box.
When the Input Fader Master check box is checked, you can set channel lev-
2
els of the Fader groups in the Master column.
When the Master column is selected, repeatedly pressing the [ENTER] button turns the
Input Fader group on and off.
02R96 Version 2—Owner's Manual