Panning Input Channels - Yamaha 02R96 Owner's Manual

Digital mixing console version 2.0
Hide thumbs Also See for 02R96:
Table of Contents

Advertisement

ALL BUS: This button assigns all Input Channels that are currently displayed to all Bus
Outs
ALL CLEAR: This button clears all routing assignments that are currently displayed.
The currently selected Surround mode is displayed in the lower-left corner. When Stereo
mode is selected, the Bus Out routing buttons display numbers from 1 through 8. When a
Surround Pan mode is selected, they display abbreviations of the Surround Channel names,
as shown in the following table. See "Using Surround Pan" on page 85 for more informa-
tion.
Surround Mode
Stereo
3-1
5.1
6.1
1. Short for LFE (Low frequency Effects).
This table shows the default assignments. The actual assignments may vary depending on
the settings on the Surround Bus Setup page. See "Assigning Surround Channels to Buses"
on page 87 for more information.

Panning Input Channels

Input Channels can be panned between the left and right channels of the Stereo Out.
Using the Encoders
1
Use the LAYER buttons to select the Layers.
Press the ENCODER MODE [PAN] button to select the Pan Encoder
2
mode.
Use the Encoders to pan the input channels.
3
Using the SELECTED CHANNEL PAN/SURROUND Controls
1
Use the LAYER buttons to select the Layers, and use the [SEL] buttons to
select the Input Channels.
Use the Pan control to pan the currently selected Input Channel.
2
The pan display indicates the pan position of the currently selected Input Channel. When
pan is set to center, the center two segments light up. You can use the [L] and [R] buttons
to select horizontal or vertical Input Channel partners.
The [LINK] button, which is enabled only when a Surround mode other than Stereo is
selected, is used to link the Pan control and the Joystick so that either control can be used
for panning. This setting applies only to Input Channels that are currently selected. For this
to work, the [EFFECT] button indicator must be off and the [GRAB] and [LINK] button
indicators must be on.
1
2
3
1
2
3
L
R
C
L
R
Ls
L
R
Ls
PAN / SURROUND
DISPLAY
L
R
L
R
ODD
EVEN
Panning Input Channels
Bus Outs
4
5
6
4
5
6
S
5
6
1
Rs
C
E
Rs
C
Bs
LINK
GRAB
EFFECT
02R96 Version 2—Owner's Manual
83
7
8
7
8
7
8
7
8
E
8

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

O2r 96 version 2

Table of Contents