Yamaha 02R96 Owner's Manual page 218

218
Chapter 18—Pro Tools Remote Layer
Panner Operation via the Joystick
Select the track you wish to pan.
1
Press the [GRAB] button, turning on the [GRAB] button indicator.
2
While the [GRAB] button indicator is lit, operate the Joystick.
3
If you move the Joystick for direct panning while the [GRAB] button indicator is lit, the pan
position is specified as an absolute value, which may cause the pan position to jump dras-
tically.
You can also restrict the trajectory direction of the Joystick. To limit movement to the L and
R directions, press and hold down the [DIRECT] button and move the Joystick. To limit
movement to the up and down (front and rear) directions, select 3 Knob mode in the Pro
Tools Panner window.
Panner Operation via Knob Controls
You can control the following parameters using the DYNAMICS controls.
THRESHOLD
RANGE/RATIO
ATTACK
DECAY/RELEASE
HOLD/GAIN
Select the track and output, if desired.
1
2 Press the ROUTING [6] button to select the knob control mode that is appro-
priate for the parameter you wish to control.
Use the appropriate control to adjust the parameter.
3
Pressing and holding down the [Command] key on the keyboard and rotating the controls
reduces the change in the parameter values.
02R96 Version 2—Owner's Manual
Controls ROUTING [6] indicator is off
Front position
Rear position
F/R position
LFE level
ROUTING [6] indicator is on
Front divergence
Rear divergence
F/R divergence
Center percentage
Channel volume