Using The Rs-232C Interface; Re-Connecting The Network - Christie Inspire 4K Series Installation And Setup Manual

Using the RS-232C interface

To control the projector through the RS-232C interface, do the following:
1. Connect your computer and the projector directly using the RS-232 cable.
2. Set the same baud rate in both your computer and projector.
3. Use commands to control the projector.

Re-connecting the network

After the network is disconnected and timeout using RJ-45/HDBaseT/Wifi, the browser refreshes the
page automatically and shows HTTP404 (Not Found) error message.
If the user wants to re-control the projector, the user must log into the control page with account
and password again.
Inspire Series Installation and Setup Guide
020-002097-01 Rev. 1 (11-2023)
Copyright ©2023 Christie Digital Systems USA Inc. All rights reserved.
If printed, please recycle this document after use.
Configuring light settings
33