Table of Contents
Advertisement
Using the Roll Unit In Take-Up Mode
Important
• For details on the roll paper compatible with winding, see "Paper Information List.".
•
• Before loading the roll paper to be taken up on the roll unit, set the roll unit mode to take-up device on
•
the printer touch screen.
Switching Roll Unit Modes
• If the roll holder is installed on the roll unit, first remove the roll holder from the roll unit, and then
•
remove the roll paper loaded on the roll holder.
Removing Roll Paper from the Roll Unit
• Paper winding is possible until the outer diameter of the wound paper is the same as the outer diameter
•
of the holder stopper.
1.
1. Store basket.
Storing the Basket on the Printer Stand
2. Rotate the holder stopper lever (A) towards
2.
end plate (B), remove the holder stopper from the roll holder.
3. If taking up roll paper whose paper core has an inner diameter of 3 inches (76.2 mm), insert
3.
3-Inch Paper Core Attachment in roll holder and holder stopper.
Align the 3-Inch Paper Core Attachment tabs (A) with the holes on the roll holder or holder stopper (B)
and insert firmly.
•
• roll holder Side
to release the lock, and while holding the
97
Advertisement
Table of Contents
Troubleshooting
