Table of Contents
Advertisement
3. Select Load paper.
3.
Note
• If any paper has been advanced that will not be used, a message is shown requesting you to
remove it. After following the instructions on the screen to remove the paper, go to the next step.
4. Change Roll Holder Lock switch on roll unit to release position.
4.
5. Hold flanges (A) so that holder stopper is on left, align roll holder shaft with roll holder slot
5.
left and right guide grooves (B), and load.
280
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the imagePROGRAF PRO-6600 and is the answer not in the manual?
Questions and answers