Canon imagePROGRAF PRO-6600 Online Manual page 602

Note
• When Auto (Use Printer Settings) is selected for the media type, printing is performed with the media •
type loaded in the printer.
• Click Get Information to reflect the paper information set in the printer to the printer driver. •
When loading paper in the printer, is the media loaded the same as the media
Check 4
type selected on the touch screen?
The platen may become dirty if the loaded paper does not match the settings. We recommend that you clean the
platen before printing again.
Cleaning Inside the Top Cover
Set the correct media type on the touch screen.
Changing the Type of Paper
Is the paper creased or curled?
Check 5
Straighten out the wrinkles or curls and reload the paper.
Loading Rolls in the Printer
Loading Roll Paper in the Roll Unit
Loading Sheets in the Printer
In the touch screen menu, is Cut-dust reduction in Advanced paper settings
Check 6
set to ON?
A cut dust reduction line is printed at the paper cut position when Cut-dust reduction is set to ON.
If cutting dust reduction is not required, set Cut-dust reduction to OFF.
Reducing Dust from Cutting Rolls
Is the Print head height set too low in the touch screen menu?
Check 7
Set Head height to the value higher than the current one.
Changing the Print Head Height
Is the paper thick, or a type that curls easily or is prone to buckling after
Check 8
absorbing ink?
• • If using paper-based printing material such as thick-coat paper, set Transport unit vacuum strength in the
touch screen menu to Medium-strong or Strong.
• If using film-based printing material such as tracing paper, set the Transport unit vacuum strength in the •
touch screen menu to Standard, Medium-strong, or Strong.
If that does not resolve the problem, increase the Head height setting in the touch screen menu.
Adjusting Vacuum Strength
Changing the Print Head Height
Is the output guide clean?
Check 9
Clean the output guide.
602