Cutter Blade Does Not Work While Cutting Is In Progress - Canon imagePROGRAF PRO-6600 Online Manual

Cutter Blade Does Not Work While Cutting Is in Progress

Does a message appear on the touch screen?
Check 1
If the cutter blade failed to cut the paper, it stops moving and a message appears on the touch screen.
Remove the paper and try printing again.
Remove Jammed Roll Paper
Make sure the cutter blade can cut paper used currently.
Check 2
Select User cut for Cutting mode in the touch screen menu and cut the roll paper with a cutting implement such
as scissors.
Specifying the Cutting Method for Rolls
Cutting Roll Paper after Printing
Check the setting value for Cut speed.
Check 3
Selecting slower value may enable the cutter blade to cut paper.
Select paper settings display area on Home screen of touch screen, select the feed slot where the paper to
change is set, then select Paper settings > Advanced and change the setting value of Cut speed.
Advanced (Paper settings)
Is the edge of the cutter blade blunt?
Check 4
Replace the cutter blade.
Replacing the Cutter Blade
685