Cannot Connect Printer To Network - Canon imagePROGRAF PRO-6600 Online Manual

Cannot Connect Printer to Network

Is the Ethernet cable connected correctly to the printer's wired LAN connector?
Check 1
Make sure the printer is connected to the network with the correct Ethernet cable, and then turn the printer on.
For instructions on connecting the cable, refer to the Setup Guide.
Make sure the Link indicator is lit.
Check 2
When the printer is connected via 1000Base-T, both the top and bottom indicators are lit.
When the printer is connected via 100Base-TX, the top indicator will light green. For 10Base-T connections the
lower indicator will light orange.
If the Link indicator is not lit, check the following points.
• The hub is on.
• • The end of the Ethernet cable is connected correctly.
Insert the Ethernet cable until it clicks and locks in place.
• • There is no problem with the Ethernet cable.
If there is any problem, replace the Ethernet cable.
630