Canon imagePROGRAF PRO-6600 Online Manual page 254

Hide thumbs Also See for imagePROGRAF PRO-6600:

Table of Contents

This item adjusts color tones to warm shades of gray (warm black). When you select Warm Tone,

a value of 30 is entered for X, and a value of 0 for Y.

You can adjust the color tones while checking the colors in the adjustment area. To adjust the color

tones, either enter values directly or click the up/down arrows. You can also adjust the color tones

by clicking or dragging the adjustment area with the mouse. If you select another color tone and

then select Custom again, the values that were preset in Custom are restored.

X, Y (Monochromatic adjustment value)

If necessary, you can adjust monochromatic colors manually. To adjust the color tones, either enter

values directly or click the up/down arrows. You can also adjust the color tones by clicking or

dragging the adjustment area with the mouse. When you enter values, set values in the range of

-100 to 100 for X, and -50 to 50 for Y. The selected value will be shown in the preview on the left

• Tone and X, Y (Monochromatic adjustment value) are displayed when Black and White Photo Print

check box is selected for Quality & Media.

• With the Quality & Media of Media Type, depending on the type of paper selected, Tone, X and Y are

grayed out and cannot be set.

For paper for which Tone, X and Y can be used, select the paper you want to use from "Paper

Information List" and check the information.

Adjusts the brightness of your print. You cannot change the levels of pure white and black. However,

the brightness of the colors between white and black can be changed. Colors become brighter as you

drag the slider toward the right and darker as you drag the slider toward the left. You can also directly

enter brightness values that are linked to the slider bar. Enter a value in the range from -50 to 50.

The Contrast function changes the differences between light and dark in images during printing.

To make the differences between the light and dark portions of images greater and more distinct,

increase the contrast. On the other hand, to make the differences between the light and dark portions of

images smaller and less distinct, reduce the contrast.

You can also directly enter a value linked to the slider. Enter a value in the range from -50 to 50.

Troubleshooting

Do you have a question about the imagePROGRAF PRO-6600 and is the answer not in the manual?