Canon imagePROGRAF PRO-6600 Online Manual page 274

Caution
• • Do not force the roll holder into the printer with the right and left ends reversed. This may damage
the printer and roll holder.
• • Do not release the flanges until the holder is loaded in the roll holder slot.
• • Be careful not to pinch your fingers between the Roll Holder shaft and the guide grooves (B) when
loading the roll paper.
Important
• If the leading edge of the roll paper is secured with tape or a paper band so that it will not unravel, •
remove the tape or paper band before loading the roll paper into the roll holder slot.
If you load the paper into the roll holder slot with the leading edge secured, only part of the roll
paper is fed to the paper feed slot, resulting in damage to the roll paper.
• If the leading edge of the roll paper is cut crooked or folded, it may not be fed correctly. Cut the •
leading edge of the roll paper with scissors or the like and straighten it.
• Load the roll paper so that it is not loaded in the opposite direction. •
• • Make sure there is no slack in the roll paper, and then load it.
• Depending on the surrounding environment, the leading edge of roll paper is stuck because of •
static electricity or humidity so that the roll paper may not be able to be fed correctly. In this case,
set Roll paper auto feed to Disable, and then feed the roll paper.
• • If the roll paper is decentered, it may not be able to be fed correctly. In this case, set Roll paper
auto feed to Disable, and then feed the roll paper.
274