Assembly Of Propeller Shaft Housing - TOHATSU MFS 4D Service Manual

9) Assembly of Propeller Shaft Housing

Ass'y
Apply gear oil to outside of new oil seal 1, and attach it to
1.
propeller shaft housing 3 by using a commercially available
mandrel 2.
GEAR
GEAR GEAR
Install new bearing 4 to propeller shaft housing 3.
2.
Do not reuse removed bearing.
Bearing Attachment 5 :
P/N. 3BV-99905-0
Driver Rod 6 :
P/N. 3AB-99702-0
GEAR
GEAR GEAR
Apply LIT grease to lip of oil seal 1.
3.
LIT
LIT
10) Removing Drive Shaft Ass'y
Pull up pump case (lower) and drive shaft ass'y 1,
1.
remove pinion (B) gear 2, and then pull out forward (A)
gear 3.
· When removing forward (A) gear 3, be careful
not to damage the existing shims or lose them.
Shim is reusable.
· Replace shim with new one of the same
thickness if any deformation or damage is
found on it.
4st 4/5/6 2020
3
1 Oil Seal
Do not reuse.
5
3
4 Oil Seal
Do not reuse.
2
3
2
1
GEAR GEAR
GEAR
6
4
GEAR GEAR
GEAR
1
LIT
LIT
6
1
6-15