Fuel Tank Line; Rigging; Inspection Of Tilt Stopper - TOHATSU MFS 4D Service Manual

5) Fuel Tank Line

1. Check that fuel tank contains sufficient amount of gasoline,
fuel line is connected and is free of leak.
Since this is a four stroke engine model, do
not use fuel mixed with engine oil. Use of
fuel mixed with engine oil will cause engine
trouble.

6) Rigging

1. Check that clamp bracket is fixed securely to hull.
2. Inspect boat bottom and atnti-ventilation plate to prevent the
engine from overheating or decreasing in propulsive force,
and, if necessary, adjust to prevent decrease in propulsive
force and engine overheating.
C o n d u c t a t e s t r u n t o d e t e r m i n e t h e b e s t
installation height.
Anti-ventilation plate standard position a :
Anti-ventilation plate located 5 - 25 mm
(0.2 - 1.0 in) below boat bottom

7) Inspection of Tilt Stopper

Fully tilt up the outboard motor, lock with the tilt stopper 1,
1.
and then check that the holding mechanism functions
normally.
4st 4/5/6 2020
CAUTION
Dual Tank model
1 ''FULL'' mark
Separate Tank model
a 5 - 25 mm (0.2 - 1.0 in)
1
1
[US]
a
1
1-9