Assembly Of Clutch Cam And Cam Rod; Removing Pump Case (Lower); Disassembly Of Pump Case (Lower) - TOHATSU MFS 4D Service Manual

Lower Unit

17) Assembly of Clutch Cam and Cam Rod

Install clutch cam 3 and spring pin 2 to cam rod 1.
1.
Spring Pin Tool B (ϕ3.0):
P/N. 345-72228-0
Be careful of direction of cam rod.

18) Removing Pump Case (Lower)

Remove pump case (lower) 1 and drive shaft ass'y 2
1.
while holding pinion (B) gear with hand.
Pinion gear (B) will drop into gear case when
pump case (lower) is removed.
2. Remove forward (A) gear from gear case.
Remove pump case (lower) 1 from drive shaft ass'y.
3.

19) Disassembly of Pump Case (Lower)

Use bladed screw driver to remove oil seal 1.
1.
6-18
1
GEAR GEAR
GEAR
3
2 Spring Pin
Do not reuse.
2
1
1 Oil Seal
Do not reuse.
Forward
direction
2
1
1
4st 4/5/6 2020