Access To Screens And Systems - Polycom VSX Series Administrator's Manual

Access to Screens and Systems

Symptom
Cannot navigate to Admin
screens — System button
is not displayed.
Cannot navigate to Admin
screens without a
password.
Cannot access the system
remotely.
Problem
The home screen is not
configured to display the
System button.
The system administrator
has set a password,
or
The default password was
not deleted.
The system does not allow
remote access.
The system or your
computer is not connected
to the LAN.
The LAN cable to the
system or to your computer
is bad.
To verify this, check the
lights on the system. There
should be a steady green
light indicating a connection
to the LAN, and a flashing
orange light indicating LAN
traffic if the cable is good.
DHCP Client is ON and no
DHCP server is available.
There is a firewall between
your computer and your
system.
Your computer is on a
different network and there
is not connectivity between
the networks.
The system is in Security
Mode, which requires
secure access.
Corrective action
Press the button on the remote and select
System at the end of the help message, or access
the system remotely using VSX Web, FTP, Telnet.
From VSX Web, you can add the System button
back to the home screen. Click System Setup and
navigate to Admin Settings > General Settings >
Home Screen Settings, then select System. The
change takes effect after you navigate away from the
home screen and then back again on the system.
Enter the password.
The default password is the system's serial number.
On the system, go to Admin Settings > General
Settings > Security >
Check the LAN cable to the LAN port on the rear of
the system.
Check the LAN cable to your computer.
Replace the appropriate LAN cable.
Contact your network administrator.
Contact your network administrator.
Place your computer and system on the same
subnet. If this corrects the problem, check your router
configuration. If it does not, contact your network
service provider.
Use secure modes of Telnet, FTP, Web, and serial
access. For more information, refer to
Security Mode on page 8-6.
Troubleshooting
and enable access.
Configuring
12 - 5