Configuring With The Setup Wizard - Polycom VSX Series Administrator's Manual

Administrator's Guide for the VSX Series

Configuring with the Setup Wizard

1 - 6
For component systems, the power switch is on the front. The indicator light
in the switch provides this information:
• Light is green — system is powered on
Light changes to from green to red, then to blue — system is powering off
•
• Light is blue — system is powered off
• Light is off — system is not connected to power
When you power on your system for the first time, the setup wizard detects
the system's SCCP connections and leads you through the minimum
configuration steps required to place a call. This guide covers only the SCCP
setup. Although the VSX SCCP system can be connected only to SCCP
networks, you can use the system to call users on other types of networks if the
CallManager is configured to allow this. Please note that not all network types
are available in all countries.
The setup wizard allows you to set a room password, which allows you to
limit access to the Admin Settings. The default room password is the 14-digit
system serial number.
Make sure you can recall the room password if you set one. If you forget the
password, you will have to reset the system, delete the system files, and run the
setup wizard again in order to access the Admin Settings and reset the password.
If Security Mode is enabled, the room password is required to access the Reset
System screen. If you forget the room password while the system is in Security
Mode, contact your Polycom distributor or Polycom Technical Support.
You can run the setup wizard or view the configuration screens in either of
these two ways.
In the room with the system — Use the remote control to navigate the
•
screens and enter information. You can use the number pad on the remote
control to enter text just like you can with a cell phone.
• From a remote location — Use a web browser to access VSX Web. For
more information about using VSX Web, refer to
page 9-1.
Accessing VSX Web on