Polycom VSX Series Administrator's Manual page 36

Administrator's Guide for the VSX Series
3 - 14
To store a preset:
1. If you are in a call, press
choose a near-site or far-site camera or other video source.
2. If you selected a camera that supports electronic pan, tilt, and zoom, you
can adjust the camera's position:
— Press the arrow buttons on the remote control to move the camera up,
down, to the left, or to the right.
— Press Zoom to zoom the camera out or in.
3. Press
Preset on the remote control.
4. Press and hold a number to store the preset position.
To store a double-digit preset (10-99), hold the second number down.
Any existing preset stored at the number you enter is replaced.
If Automatic Camera Tracking to Presets will be used during calls, set
preset 0 to a wide shot of the room. When Automatic Camera Tracking to
Presets is enabled and no one speaks for 30 seconds, the camera
automatically moves to preset 0.
To delete all presets:
1. If a call is connected, press
2. Press
Preset on the remote control.
3. Press
Delete to delete all presets.
Near or Far on the remote control to
Near to choose a near-site video source.