Polycom VSX Series Administrator's Manual page 80

Administrator's Guide for the VSX Series
8 - 4
To set or change the remote access password:
1. Go to System > Admin Settings > General Settings > Security.
2. Clear the Use Room Password for Remote Access setting if it is selected.
By default, the remote access password is the same as the room
password.
3. Enter a Remote Access password.
To access Admin Settings using VSX Web when a remote access password is
set, enter "admin" for the user name.
To use the same password for both local and remote access:
1. Go to System > Admin Settings > General Settings > Security.
2. Select Use Room Password for Remote Access.
To reset a forgotten password:
1. Get the system's serial number from the system or from the System
Information screen.
2. Go to System >Diagnostics > Reset System.
If Security Mode is enabled, the room password is required to access the Reset
System screen. If you forget the room password while the system is in Security
Mode, contact your Polycom distributor or Polycom Technical Support.
3. Enter the system's serial number and select Delete System Settings.
4. Select Reset System.
After the system resets, it leads you through the setup wizard. You can enter a
new password when you set up the system.