Disassembly Procedures - Agilent Technologies E8285A Manual

Disassembly Procedures

This section provides instructions for disassembling the Test Set. The
procedures provided in this chapter are mainly organized in sequential
order of Test Set disassembly. For component and assembly part
numbers refer to the
used in the following illustrations are the same as their descriptions in
the parts list.
External and Internal Covers
1. Remove the rear bumpers – two screws secure each bumper. See
2. Remove the strap handles (STRAP_HANDLE) from the Test Set.
3. Slide the external cover from the front frame.
4. To access the top-side assemblies remove the screws securing the top
5. To access the bottom-side assemblies remove the screws securing the
Figure 3-1 Cover Removal
COVER_EXTERNAL
TRIM_STRIP_2
TRIM_STRIP_1
(Qty. 2)
"Parts List" on page
Figure 3-1.
internal covers and remove it. See
bottom internal cover and remove it. See
Disassembly and Replaceable Parts
Disassembly Procedures
105. The callouts for the parts
Figure 3-2 on page 88.
Figure 3-2 on page
BUMPER-REAR
AY,_STRAP_HANDLE
88.
87