Rf Analyzer Level Accuracy; Performance Test 19 - Agilent Technologies E8285A Manual

RF Analyzer Level Accuracy

Performance Test 19

The purpose of this test is to verify that the Test Set meets the specification limits
in PTR (Performance Test Record)
19 Record" on page
calibration program that resides on a memory card.
Procedure
1. Obtain the memory card (see
2. Run the System Power Calibration as follows:
3. Follow the instructions as they are presented. As the power difference is
Figure 6-24
Signal Generator
236. Level accuracy is measured using a system power
Power Calibration software program.
a. Insert the memory card into the memory card slot.
b. Select the SOFTWARE MENU screen.
c. Set the Select Procedure Location: field to Card.
d. Set the Select Procedure Filename field to SYSPWR0.
e. Press the Run Test key.
displayed, write these numbers in the Performance Test Record and compare
them with the limits. (If two passes are chosen, average the two sets of data.)
After the acquisition of levels is complete, select No when asked if you want
the calibration factors downloaded into the Test Set's memory.
Measuring Receiver
RF Analyzer Level Accuracy Performance Test 19
table 7-19, "RF Analyzer Level Accuracy Test
Table 6-1 on page 143) containing the System
POWER RF IN/OUT
DO NOT apply RF Max power 2.5W
when in standby
RF IN/OUT
SENSOR
INPUT 50Ω
Performance Tests
CALL CONTROL UTILITIES
Answer Print Printer I/O config Help
Call/ End/ Register Tests Config Previous Message Preset
Page Release
Hold
Meas
CDMA SCREENS ANALOG SCREENS
USER reset
Cell config Spectrum SMS Address
Call Gen Authen- Call Duplex Spectrun Local
K1' control control tication control analyzer
K1 MS report MS FER Save
RX test TX test TX RX test TX test AF Recall
range analyzer
K2'
K2
DATA FUNCTIONS DATA
K3'
Ref set Meter Average
K3 Increment Increment Increment 7 8 9 Enter
10 set x 10
Low limit High limit
Assign
K4 4 5 6 Ghz
dBm
dB
Release
K5
1 2 3 MHz
V
%
kHz
0 . +/-
mV
s
IBASIC
mW
reset
Yes No % Hz
Shift Cancel
On/Off Ratio dB µV
W ms
DUPLEX OUT ANTENNA IN VOLUME AUDIO OUT AUDIO IN
High Low
Max power 60 mW Max 12V peak Max
42V peak
Sensor Module
179