Table of Contents
Advertisement
Service Screen
Troubleshooting with the SERVICE Screen
• out: Output
• rcvr: Receiver
• gsyn: Signal Generator Synthesizer
• rsyn: Receiver Synthesizer
• spec: Spectrum Analyzer
• meas: Measurement
• metron: Measurement
• afg1: Signaling Source/Analyzer
• afg2: Signaling Source/Analyzer
• sgnl: Displays version number of the Signaling Source/Analyzer
firmware.
• cellSite1: Cell Site 1 Digital board
• cellSite2: Cell Site 2 Digital board
• cdmaRef: CDMA Reference
• iq_mod: I/Q Modulator
• loif: LO/IF Demod
• main_dsp: Main DSP Receiver
• aux_dsp: optional DSP Receiver
• protocol: Protocol Processor
Value (hex)
This field displays and changes the value for the latch shown in the
Latch field.
RAM Initialize
Selecting this field clears all SAVE registers and test programs, and
any initialized RAM disk(s), that may be in RAM. It also resets all
latches to their factory power-up configuration. If you have saved one or
more instrument setups using the SAVE function, using this function
will permanently remove them.
297
Advertisement
Table of Contents
Troubleshooting
