Agilent Technologies E8285A Manual page 128

Periodic Adjustments/Calibration
Periodic Adjustments
Test Equipment
Test Equipment for the Periodic Adjustments Programs
• For the Timebase Reference Using a Counter calibration you will
• For the Timebase Reference Using a Source calibration you will
• For the Voltmeter References calibration you will need a DC voltmeter
Figure 5-1 Periodic Calibration Menu
128
S:\agilent\e8285\ALR\Book\chapters\period_adj.fm
need to connect a frequency counter to the rear-panel 10 MHz REF OUTPUT
connector. The accuracy of the counter will determine the accuracy of the Test
Set's internal reference. You will use the counter to set the timebase reference
DACs.
need to connect a signal generator to the front-panel ANTENNA IN connector.
that can measure ±5 V with ±0.015% accuracy.