Agilent Technologies E8285A Manual page 60

Troubleshooting
Functional Diagnostics
5. Set up the Test Procedure Run Mode: field.
6. Verify that the Autostart Test Procedure on Power-Up: setting is Off.
Configuring a Printer
Only perform the following steps if you want to print test results to a printer.
1. Press the Tests key.
2. On the TESTS (Main Menu) select Print Printer Setup . The TESTS
Figure 2-12 TESTS (Execution Conditions)
3. Under PRINT SETUP:, select Model: and the printer of your choice.
4. Set the Printer Port: for the side-panel connector your printer is connected to
5. Under PAGE CONTROL:, set the Lines/Page: and Form Feed (FF at Start:,
60
S:\agilent\e8285\ALR\Book\chapters\trouble.fm
• Select Continuous to run the tests continuously.
• Select Single Step to pause after each measurement.
(Printer Setup) screen appears.
(Parallel 15, Serial 9, or GPIB).
If an GPIB printer is used, you need to enter the printer's two-digit bus address
when the Printer Adrs field appears (Example; enter 1 or 01 for bus address
701). Also, press the
Shift
CONFIGURE screen, and set the Mode field to Control.
and FF at End:) parameters if necessary.
key, then the
INST CONFIG
key to access the I\O