Language Reference
TRIGger Subsystem
RF Burst Trigger Level
:TRIGger[:SEQuence]:RFBurst:LEVel <percent>
:TRIGger[:SEQuence]:RFBurst:LEVel?
Set the trigger level when using the RF Burst (wideband) Trigger. The
value is relative to the peak of the signal. RF Burst is also known as RF
Envelope.
Factory Preset
−6.0 dB
and *RST:
−25.0 to 0.0 dB
Range:
−200.0 to 0.0 dB for NADC, PDC
Default Unit:
dB
Front Panel
Access:
Mode Setup
RF Burst Trigger Slope
:TRIGger[:SEQuence]:RFBurst:SLOPe NEGative|POSitive
:TRIGger[:SEQuence]:RFBurst:SLOPe?
Set the trigger slope when using the RF Burst (wideband) Trigger.
Factory Preset
and *RST:
Positive
Remarks:
You must be in the cdmaOne, cdma2000, W-CDMA
(3GPP), or W-CDMA (Trial & ARIB) mode to use this
command. Use :INSTrument:SELect to set the mode.
Front Panel
Access:
Mode Setup, Trigger, RF Burst, Slope
378
,
Trigger, RF Burst, Peak Level
Chapter 5