Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 446

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > CCD
DFCH2R10 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
DFCH2B2 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
DFCH2B10 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
DFCH2G2 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
Complex chart No.10 data (R) entry:front
To derive the front/back side linearity, enter the Red data on the front side of No.10 image in DADF
complex chart.
Enter the value of service label on the Reader.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 2550
0
COPIER> ADJUST> CCD> DFCH2R2, DFCH2B2/10, DFCH2G2/10
1
Complex chart No.2 data (B) entry: front
To derive the front/back side linearity, enter the Blue data on the front side of No.2 image in DADF
complex chart.
Enter the value of service label on the Reader.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
1 to 2550
2000
COPIER> ADJUST> CCD> DFCH2R2/10, DFCH2B10, DFCH2G2/10
1
Complex chart No.10 data (B) entry:front
To derive the front/back side linearity, enter the Blue data on the front side of No.10 image in DADF
complex chart.
Enter the value of service label on the Reader.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 2550
0
COPIER> ADJUST> CCD> DFCH2R2/10, DFCH2B2, DFCH2G2/10
1
Complex chart No.2 data (G) entry: front
To derive the front/back side linearity, enter the Green data on the front side of No.2 image in
DADF complex chart.
Enter the value of service label on the Reader.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
1 to 2550
2000
COPIER> ADJUST> CCD> DFCH2R2/10, DFCH2B2/10, DFCH2G10
1
435
8. Service Mode