Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 501

COPIER (Service mode for printer) > FUNCTION (Operation / inspection mode) > SYSTEM
FIXIP 1
Detail
Use Case
Adj/Set/Operate Method
Caution
■ DBG-LOG
COPIER (Service mode for printer) > FUNCTION (Operation / inspection mode) > DBG-LOG
LOG-TRIG 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Related Service Mode
HIT-STS 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Related Service Mode
DEFAULT 2
Detail
Use Case
Adj/Set/Operate Method
LOG-DEL 2
Detail
Use Case
Adj/Set/Operate Method
Start of fixed IP mode
IP address is set to "172.16.1.100".
In an environment where wired LAN (main) and wireless LAN (sub) are used, the IP address of
wired LAN becomes the fixed IP.
During the fixed IP mode, "FIXIP" is displayed on the upper left of the screen.
When preferring to use the network settings with the fixed IP address "172.16.1.100"
Select the item, and then press OK key.
- It is necessary to turn OFF/ON the power to recover from the fixed IP mode.
- Whether to use RUI or not when the fixed IP mode is enabled follows the setting of "Management
Settings> License/Other> Remote UI.
Set of debug log storage condition
To set the conditions (timing, types, etc.) to automatically store the debug logs (stored as an archive
file).
By reading the operation setting file of the setting value from the Main Controller, the conditions
written in the file are set.
When setting a new condition is necessary, read the operation setting file provided by R&D from
the USB memory.
- When changing the conditions of debug log to automatically store
- When setting a new condition
Enter the setting value, and then press OK key.
0 to 99999
COPIER> FUNCTION> DBG-LOG> LOG2USB, LOG2SRVR
Display of debug log state
To display whether archive file of the debug log which is matched with the conditions set in LOG-
TRIG exists or not.
When checking the debug log automatically saved
N/A (Display only)
0 to 1
0: No log is available, 1: Log is available
COPIER> FUNCTION> DBG-LOG> LOG-TRIG
Reset of debug log setting
To clear all debug log settings and return to the state before debug log collection operation.
- When returning the device in which analyzing the cause of a problem was completed
- When resetting the debug log settings
Select the item, and then press OK key.
Clearing of debug logs
To delete the debug log file.
The debug log setting is not reset.
When clearing the debug log
Select the item, and then press OK key.
490
8. Service Mode