Alarm Code; Alarm Code Details - Canon imageRUNNER ADVANCE 715iF III Series Service Manual

Alarm Code

Alarm Code Details

00-0085
A. Operation / B. Cause /
C. Remedy
00-0246
A. Operation / B. Cause /
C. Remedy
00-0247
A. Operation / B. Cause /
C. Remedy
01-0002
A. Operation / B. Cause /
C. Remedy
04-0076
A. Operation / B. Cause /
C. Remedy
04-0077
A. Operation / B. Cause /
C. Remedy
04-0078
A. Operation / B. Cause /
C. Remedy
10-0020
A. Operation / B. Cause /
C. Remedy
10-0094
A. Operation / B. Cause /
C. Remedy
A notice of state
-
Error code display (4-digit)
Soft counter PCB cannot write normally
Error code display (4-digit)
Soft counter PCB cannot restore data
No change in device status after specified period of time has passed (RDS server creates)
-
OP Cassette 2 Memory Error
Cause: Communications cannot be made with the Control PCB of OP Cassette 2 or data error
occurs.
Remedy:
1. Check on the connection of OP Cassette 2
2. Check on the connector of the Control PCB of OP Cassette 2
3. Replacement of the Control PCB of OP Cassette 2
4. Replacement of the DC Controller PCB
OP Cassette 3 Memory Error
Cause: Communications cannot be made with the Control PCB of OP Cassette 3 or data error
occurs.
Remedy:
1. Check on the connection of OP Cassette 3
2. Check on the connector of the Control PCB of OP Cassette 3
3. Replacement of the Control PCB of OP Cassette 3
4. Replacement of the DC Controller PCB
OP Cassette 4 Memory Error
Cause: Communications cannot be made with the Control PCB of OP Cassette 4 or data error
occurs.
Remedy:
1. Check on the connection of OP Cassette 4
2. Check on the connector of the Control PCB of OP Cassette 4
3. Replacement of the Control PCB of OP Cassette 4
4. Replacement of DC Controller PCB
Toner (Bk) prior notification alarm
The life value of a target part reached the number of days left as set in COPIER > OPTION > PM-
DLV-D > TONER-K.
Toner memory detection error (Bk):
Communication error with the memory of toner (Bk) was detected.
Cause: Memory of toner (Bk) could not be detected.
1. Remove and then install the Toner Cartridge.
2. Check for any scar or soiling on the memory area of the Toner Cartridge.
3. Check the connector between the memory detection area and the DC Controller PCB.
4. Check for any soiling or damage on the memory detection area.
5. Replace the Toner Cartridge (Bk)
343
7. Error/Jam/Alarm