Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 437

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > CCD
DFTAR-R 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
DFTAR-G 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
DFTAR-B 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
Enter shading target VL (R): front, 1st
To enter the shading target value of Red on the front side at the first reading position at DADF
stream reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Copyboard Glass/Scanner Unit (Front), execute DF-WLVL1 and DF-WLVL2
and write the value which is automatically set in the service label.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Copyboard Glass/Scanner Unit (Front)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 2047
1103
COPIER> FUNCTION> CCD> DF-WLVL1/WLVL2
1
Enter shading target VL (G): front, 1st
To enter the shading target value of Green on the front side at the first reading position at DADF
stream reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Copyboard Glass/Scanner Unit (Front), execute DF-WLVL1 and DF-WLVL2
and write the value which is automatically set in the service label.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Copyboard Glass/Scanner Unit (Front)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 2047
1111
COPIER> FUNCTION> CCD> DF-WLVL1/WLVL2
1
Enter shading target VL (B): front, 1st
To enter the shading target value of Blue on the front side at the first reading position at DADF
stream reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Copyboard Glass/Scanner Unit (Front), execute DF-WLVL1 and DF-WLVL2
and write the value which is automatically set in the service label.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Copyboard Glass/Scanner Unit (Front)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 2047
1164
COPIER> FUNCTION> CCD> DF-WLVL1/WLVL2
1
426
8. Service Mode