Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 301

E015-0003-05
Detection Description
Remedy
E015-0004-05
Detection Description
Remedy
E020-04C0-05
Detection Description
Remedy
E021-0001-05
Detection Description
Remedy
Cassette 3 Lifter Motor error
The paper surface could not be detected by the Paper Surface Sensor after the Lifter Motor was
driven.
[Related parts]
- Cassette 3 Lifter Motor
- DC Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
1. Remove the paper in the cassette and open/close the cassette.
2. Check the operation of the Lifter Motor in light of whether the Paper Level Lever can be lowered.
a. When the motor is operated:
1. Check the installation condition of the Cassette 3 Paper Surface Sensor
2. Check the harness/connector between the DC Controller PCB and the Cassette 3 Paper Surface
Sensor
3. Check the Cassette 3 Paper Surface Sensor
4. Replace the DC Controller PCB
b. When the motor is not operated, take the following steps:
1. Check the harness/connector between the DC Controller PCB (J301) and the Cassette 3 Lifter
Motor
2. Check the condition of the gear on the side of the host machine (if there is any cut or if it swings)
3. Replace the Cassette 3 Lifter Motor
4. Replace the DC Controller PCB
Cassette 4 Lifter Motor error
The paper surface could not be detected by the Paper Surface Sensor after the Lifter Motor was
driven.
[Related parts]
- Cassette 4 Lifter Motor
- DC Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
1. Remove the paper in the cassette and open/close the cassette.
2. Check the operation of the Lifter Motor in light of whether the Paper Level Lever can be lowered.
a. When the motor is operated:
1. Check the installation condition of the Cassette 4 Paper Surface Sensor
2. Check the harness/connector between the DC Controller PCB and the Cassette 4 Paper Surface
Sensor
3. Check the Cassette 4 Paper Surface Sensor
4. Replace the DC Controller PCB
b. When the motor is not operated, take the following steps:
1. Check the harness/connector between the DC Controller PCB (J301) and the Cassette 4 Lifter
Motor
2. Check the condition of the gear on the side of the host machine (if there is any cut or if it swings)
3. Replace the Cassette 4 Lifter Motor
4. Replace the DC Controller PCB
Detection of Cartridge Shipping Lock
A shipping lock was detected during the detection of presence/absence of cartridge.
[Related parts]
- Toner cartridge
[Remedy] Check/replace the related harness/cable, connector and parts.
1. Remove the shipping lock of the toner cartridge.
2. Replace the toner cartridge.
Drum Motor error
No changes are made in the Developing Disengagement Sensor within the specified period of time
after the operation of the Developing Disengagement Solenoid.
[Related parts]
- Drum Motor (M2)
- Developing Disengagement Solenoid (SL2)
- Toner cartridge
[Remedy] Check/replace the related harness/cable, connector and parts.
290
7. Error/Jam/Alarm