Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 307

E315-0033-00
Detection Description
Remedy
E315-0035-00
Detection Description
Remedy
E315-0500-00
Detection Description
Remedy
E315-0510-00
Detection Description
Remedy
E315-0520-00
Detection Description
Remedy
E315-0530-00
Detection Description
Remedy
E315-0531-00
Detection Description
Remedy
Image process device timeout error
Processing to clear image data in the memory was not completed normally within the specified
period of time (120 sec).
Perform the following in the order while checking whether the error is cleared.
1. Reinstall the latest system software using SST or a USB flash drive.
2. Check/replace the Main Controller PCB.
Image process device timeout error
Processing to clear image data in the memory was not completed normally within the specified
period of time (120 sec).
Perform the following in the order while checking whether the error is cleared.
1. Reinstall the latest system software using SST or a USB flash drive.
2. Check/replace the Main Controller PCB.
Image process device timeout error
Transfer of image signal was not completed within the specified period of time (120 sec) at
scanning.
[Related parts]
- Harness between the CIS Unit and Main Controller PCB
- Main Controller PCB
[Remedy] Perform the following in the order while checking whether the error is cleared.
1. Reinstall the latest system software using SST or a USB flash drive.
2. Check/replace the related harness/cable, connector and parts.
Image process device timeout error
Image processing was not completed within the specified period of time (30 sec) at scanning.
[Related parts]
- Harness between the CIS Unit and Main Controller PCB
- Main Controller PCB
[Remedy] Perform the following in the order while checking whether the error is cleared.
1. Reinstall the latest system software using SST or a USB flash drive.
2. Check/replace the related harness/cable, connector and parts.
Image process device timeout error
Image processing was not completed within the specified period of time (120 sec) at scanning.
Perform the following in the order while checking whether the error is cleared.
1. Reinstall the latest system software using SST or a USB flash drive.
2. Check/replace the Main Controller PCB.
Image process device error
Compression processing of the scanned image into JPEG was terminated abnormally.
Perform the following in the order while checking whether the error is cleared.
1. Reinstall the latest system software using SST or a USB flash drive.
2. Check/replace the Main Controller PCB.
Image process device timeout error
Compression processing of the scanned image into JPEG was not completed within the specified
period of time (120 sec).
[Related parts]
- Harness between the Reader Controller PCB and Main Controller PCB
- Main Controller PCB
- Reader Controller PCB
[Remedy] Perform the following in the order while checking whether the error is cleared.
1. Reinstall the latest system software using SST or a USB flash drive.
2. Check/replace the related harness/cable, connector and parts.
296
7. Error/Jam/Alarm