Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 507

COPIER (Service mode for printer) > OPTION (Specification setting mode) > FNC-SW
LOCLFIRM 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
SDLMTWRN 1
FAX-INT 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
CDS-LVUP 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Additional Functions
Mode
Supplement/Memo
Set to allow firmware update by file
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to permit the user (administrator) to update the firmware from the remote UI using
a local file.
This update is executed as a measure for vulnerability in emergency situations.
When allowing the administrator to update the firmware using a file
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Disabled, 1: Enabled
1
[For customization]
Set FAX RX print interruption oprtn mode
To set the mode performing interruption operation of FAX reception print automatically.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
- Do not set this item while charge management (charging by Coin Manager, a device alone, etc.)
is used.
- During an ongoing job for which delivery setting (offset, stapling, etc.) is made, interruption
operation is performed between sets.
0 to 1
0: Normal, 1: Interruption operation mode
0
Set to allow CDS periodical update
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to allow the user (administrator) to perform periodical update linked with CDS.
When 1 is set, setting of periodical update can be made in Settings/Registration menu/via remote
UI.
When 2 is set, setting of periodical update can be made on the Updater screen in service mode.
When allowing the user/service technician to perform periodical update
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 2
0: Prohibited periodical update
1: Display the periodical update setting screen in Settings/Registration menu/on remote UI
2: Display the periodical update setting screen on the Updater in service mode
It differs according to the location.
Updater
Management Settings> License/Other> Register/Update Software> Periodical Update
CDS: Contents Delivery System
496
8. Service Mode