Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 532

■ FEED-SW
COPIER (Service mode for printer) > OPTION (Specification setting mode) > FEED-SW
EVLP-FS 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
TFL-RTC 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Additional Functions
Mode
SP-SW 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Set of fix speed when feeding envlp
To set the stop and the fixing speed of arch control when feeding envelope.
The fixing speed can be set by 0.5% increments.
Decrease the value when fine line displacement occurs on trailing edge of envelope, and increase
the value when wrinkles occur.
When fine line displacement or wrinkles occur on trailing edge while feeding envelope
Enter the setting value, and then press OK key.
Be sure to set the value a little at a time. Otherwise, fixing offset/fixing failure occurs when setting
an extreme value.
-4 to 3
-4: No arch control/fixing speed-2.0%
-3: No arch control/fixing speed-1.5%
-2: No arch control/fixing speed-1.0%
-1: No arch control/fixing speed-0.5%
0: OFF (Default)
1: No arch control/fixing speed+0.0%
2: No arch control/fixing speed+0.5%
3: No arch control/fixing speed+1.0%
0
Set delvry dest at rcvry after tray full
To select the delivery destination for a job with multiple pages after recovering the Delivery Tray
that reaches the full level.
When 0 is set, a job is output from the delivery destination again from which the last job was
delivered.
When 1 is set, a job is output from the delivery destination which priority is set as high at "Output
Tray Settings" in [Settings/Registration].
When changing the delivery tray
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Output from the tray from which the last job was output, 1: Output from the delivery destination
which priority is high among the delivery trays
0
Function Settings> Common> Paper Output Settings> Output Tray Settings
Disable static elimination control
To set the value to 1 to change the static eliminator bias value to 0V.
When white spots are generated on thin/moist paper in high humidity environment due to excessive
static elimination bias
Enter the setting value, and then press OK key.
0 to 1
0: Static elimination bias ON, 1: static elimination bias OFF
0
521
8. Service Mode