Canon imageRUNNER ADVANCE 715iF III Series Service Manual page 343

E733-0002-05
Detection Description
Remedy
E733-0004-05
Detection Description
Remedy
E733-0005-05
Detection Description
Remedy
E733-0010-05
Detection Description
Remedy
E733-0F00-05
Detection Description
Remedy
Printer communication error
Signal error was detected after establishment of communication between the DC Controller PCB
and the Main Controller PCB.
[Related parts] R1.00
- Harnesses between the DC Controller PCB and the Main Controller PCB
- DC Controller PCB
- Main Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] Before replacing the DC Controller PCB, back up the service mode data (approx. 2
min) and restore the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMRES
Printer communication error
Signal error was detected after establishment of communication between the DC Controller PCB
and the Main Controller PCB.
[Related parts] R1.00
- Harnesses between the DC Controller PCB and the Main Controller PCB
- DC Controller PCB
- Main Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] Before replacing the DC Controller PCB, back up the service mode data (approx. 2
min) and restore the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMRES
Printer communication error
Signal error was detected after establishment of communication between the DC Controller PCB
and the Main Controller PCB.
[Related parts] R1.00
- Harnesses between the DC Controller PCB and the Main Controller PCB
- DC Controller PCB
- Main Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] Before replacing the DC Controller PCB, back up the service mode data (approx. 2
min) and restore the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMRES
Printer communication error
A communication error between the DC Controller PCB and the Main Controller PCB was detected.
[Related parts] R1.00
- Harnesses between the DC Controller PCB and the Main Controller PCB
- DC Controller PCB
- Main Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] Before replacing the DC Controller PCB, back up the service mode data (approx. 2
min) and restore the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMRES
Printer communication error
Communication error that can be recovered by reboot
If it is detected again immediately after reboot, E733-0000 is generated.
It is not necessary to perform a remedy because the machine is automatically rebooted after log
collection.
332
7. Error/Jam/Alarm