Mounting / Installing / Connecting; Safety Measures During Assembly - Siemens VersiCharge Operating Instructions Manual

Mounting / Installing / Connecting

4.1

Safety measures during assembly

General information
Charging of electric cars must guarantee high electrical performance over long periods. The
installation and pre-installation of the charging station must comply with the power
requirements. To ensure that these requirements are fulfilled correctly, these installation
instructions are intended for qualified and trained electricians. As a qualified electrician, you
are responsible for safety, not only during installation, but also during subsequent use by the
operator and the end user.
To this end, follow The five safety rules for electrical work (Page 13).
Mount the charging station on a load-nearing wall or on a stele intended for this purpose.
Feed the cables through the base of the charging station.
Risk of electric shock due to exposed electrical connections and components
Before starting the installation work, check that the supply cable has been disconnected
from the mains and secured against restart.
Do not connect the charging station if damage or tampering is visible.
Follow all safety instructions. This will help you avoid hazardous situations that could result
in serious injury or death.
Comply with all national requirements for testing the installation. Only qualified personnel
may install the charging station. The following points described the step-by-step installation
of the charging unit. Additional steps may be necessary in your location of use. These
assembly instructions therefore do not claim to be exhaustive.
See also
Preparation before assembly (Page 24)
VersiCharge AC Wallbox IEC
Operating Instructions, 03/2021, A5E50366109-AA
DANGER
WARNING
4
23