Table of Contents
Advertisement
Mounting / Installing / Connecting
4.1
Safety measures during assembly
General information
Charging of electric cars must guarantee high electrical performance over long periods. The
pre-installation of the power supply and the installation of the Wallbox must comply with the
power requirements. To ensure that these requirements are fulfilled correctly, these
installation instructions are intended for qualified and trained electricians. As a qualified
electrician, you are responsible for safety, not only during installation, but also during
subsequent use by the operator and the end user.
To this end, follow The five safety rules for electrical work (Page 13).
Mount the Wallbox on a load-bearing wall or on a column intended for this purpose.
Route the cables from below to the Wallbox.
Risk of electric shock due to exposed electrical connections and components
Before starting the installation work, check that the supply cable has been disconnected
from the mains and secured against restart.
Do not connect the Wallbox if damage or tampering is visible.
Follow all safety instructions. This will help you avoid hazardous situations that could result
in serious injury or death.
Comply with all national requirements for testing the installation. Only qualified personnel
may mount the Wallbox. The following points describe the step-by-step mounting of the
Wallbox. Additional steps may be necessary at your location of use. These assembly
instructions therefore do not claim to be exhaustive.
28
DANGER
WARNING
VersiCharge AC Wallbox Operating Instructions ERK
Operating Instructions, 08/2023, A5E51549696-AC
4
Advertisement
Table of Contents
Troubleshooting
