Charging The Vehicle; Terminating The Charging Process - Siemens SICHARGE UC 150 Operating Instructions Manual

Operation
9.3 Operation via HMI
9.3.1

Charging the vehicle

To charge the vehicle, proceed as follows:
1. Check whether the charging point is available.
2. If an authentication method is used, select the charging point and follow the instructions
on the HMI. The following options are possible depending on the device design:
– If only RFID is installed, the authentication request is displayed. Hold your RFID card in
– If only PIN authentication is used, the authentication request is displayed. Enter the
– If RFID and the PIN authentication are possible, select an authentication method and
3. Connect the plug to the vehicle.
4. Wait until the connection is established.
5. When the charging process is running, "Charging in progress" is displayed on the HMI. You
can, for example, see the status of the vehicle battery on the HMI.
Explosion or electric shock
If you use a damaged charging cable or a damaged charging socket, you may cause
explosions, electric shock or short-circuits.
• Check the charging cable, the charging plug and the charging socket of the vehicle for
• Do not use a damaged charging cable.
• Do not plug the charging plug into a damaged charging socket.
• If the charging cable or the plug-in connection is damaged during charging, immediately
9.3.2

Terminating the charging process

The charging process can be ended automatically or manually.
Automatic termination
The following scenarios result in automatic termination of the charging process:
• Vehicle ends charging process
• Vehicle detects a fault
• Charging station detects an internal critical error (internal)
• Emergency off is triggered
– By actuating the DC shutdown button
– By opening the device doors (external)
114
front of the card reader. If the reading is successful, the card reader emits an acoustic
signal and the reader LED flashes.
numerical PIN and press "Confirm".
follow the corresponding instructions above.
DANGER
damage before each use.
press the DC shutdown button of the charging station.
Operating Instructions, 02/2023, A5E50068475-AB
SICHARGE UC 150