Table of Contents
Advertisement
IMBER SMART – Industrial Series
Chapter 1 Safety Precautions
The following sections describe the safety precautions to take when handling your device.
Read all installation instructions before using, installing, or connecting the system to the power source.
Please check the User Information Guide that accompanies the equipment for any additional requirements.
Save these instructions for future use.
1.1 Risk identification
NOTE:
Please read carefully. You might perform an action that could result in damage to equipment or loss of data.
CAUTION:
Indicates a potentially hazardous situation that, if not avoided, could result in minor or moderate injury.
WARNING:
Indicates a potentially hazardous situation that, if not avoided, could result in death or serious injury.
1.2
Installation and operation
Electromagnetic Compatibility
NOTE:
This product may cause interference if used in residential areas. Such use must be avoided unless special
measures are taken to reduce electromagnetic emissions to prevent interfering with the reception of radio
and television broadcasts.
Installation of the Power Supply
WARNING:
The device must receive power from a Limited Power Source (LPS) that does not exceed 18VA and the current
rating of the overcurrent protection should not exceed 2A.
The router can be powered from an external power source that supplies between 9 and 48 VDC. It must be used with
a certified (CE or equivalent) power supply that has a limited (LPS) and SELV/ES1 (IEC/EN 62368-1) circuit output.
We recommend using the device with the power adapter supplied. Please refer to the installation notes provided in
section 3.10 "Installing the Power Supply".
Before working on the power connections, disconnect the device from the power source and make sure it will not be
reconnected accidentally.
Requirements for GPIOs and Other Similar Devices
WARNING:
All systems connected to the device interfaces must meet the requirements for SELV (Safety Extra Low
Voltage)/ES1 (Electrical energy Source class 1) systems and/or must be designed for indoor use.
Please refer to the notes below in Chapter 8 "Appendix C -Digital IO Scenario".
User Manual
Page 5 / 92
Advertisement
Table of Contents
Need help?
Do you have a question about the IMBER SMART and is the answer not in the manual?
Questions and answers